I2C === Matthias Trute Version 1.0.1 - 2016-10-19 This package provides some more or less generic I2C related words. They are generic in a sense that they depend on a low level hardware driver, that provides some very basic routines to access the I2C interface. They are still specific to amforth, visit http://amforth.sourceforge.net/TG/recipes/I2C-Generic.html They are tested with amforth on an Atmega with it's hardware I2C module called TWI. i2c.frt ------- above the specific driver words some generic but still low level words. i2c.begin -- starts a I2C bus cycle i2c.end -- ends a I2C bus cycle i2c.n> -- send n bytes to device (n> means from data stack) i2c.>n -- read n bytes from device (>n means to data stack) i2c-detect ---------- This command scans the bus and prints a small overview over the addresses that respond to the ping. (ATmega1280)> i2c.detect 0 1 2 3 4 5 6 7 8 9 A B C D E F 0: -- -- -- -- -- -- -- -- -- 10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 20: -- -- -- -- -- -- -- 27 -- -- -- -- -- -- -- -- 30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 40: -- -- 42 -- -- -- -- -- -- -- -- -- -- -- -- -- 50: 50 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 70: -- -- -- -- -- -- -- -- ok The tool and the output is designed to mimic a linux tool of the same name. i2c-eeprom* ----------- The 24Cxx chips using 2 byte addresses are supported. The interface uses the block wordset API. The API transfers the standard block size to a fixed block buffer defined outside of this package.